Selection Guide

These descriptions give a quick overview of each product.

Gamma Radiation

This all-transistor pedal provides high gain hard clipping with both pre- and post- tone controls for maximum flexibility. Very crunchy and full.

Reverb

Basic single-control reverb where all four analog delays are timed to match those of a standard room with minimal overlap. Dry mix is wideband and does not impact your main tone in any way.

Replicate

This pedal creates two ground-isolated copies of the main channel signal for when running multiple amps or an amp and PA at same time.

Fuzz

Medium gain Fuzz Face type circuit with a clever modification to raise input impedance allowing pedal to be used anywhere in chain.

NeoKlon

Completely re-designed and improved circuit. Lowest noise floor of any Klon on the planet.

Tsar Face

Same as Fuzz but with a brilliant bias stabilization circuit added to maintain tonality over temperature swings, a common problem with other germanium pedals.

Tsar Boost

Single germanium transistor boost circuit with tone control.

Tsar Octave

Germanium octave-up pedal, perfect for driving other overdrive or distortion pedal.

Brilliantly simple starved-plate circuit that brings out all those wonderful tube characteristics (sag, compression, harmonics) that making playing guitar a lot more fun. EQ is flat so you can put anywhere in chain bringing life to an otherwise bland solid-state rig.

Compressor

Using a custom opto-resistor element and feed-forward side-chain, this pedal provides a very natural and balanced response without changing tone whatsoever. This will be one of your always on pedals.

Booster

Add clean, but harmonically enriched gain to your rig.

Reactivator

This starved-plate overdrive pedal builds on the Valve circuit by adding pre-gain before tube and post-tone for a wide range of sounds. The Boost footswitch adds in an extra 10dB gain for solos.

Power Baby

This unique pedal re-creates an entire push/pull tube output stage (including phase inverter) that can easily be overdriven into saturation for those massive rock tones at any stage volume. Place this in front of a cabinet IR for silent-stage operation into a PA. Downsize your massive rig into a pedal.

TubeKlon

A complete re-thinking of the classic pedal but implemented using only a few transistors and a tube, providing a much more realistic overdriven tube amp tonality (because it is a tube). Best sounding Klon on the planet.

Overdrive Clipper

This is a modern re-creation (not a copy) of a Dumble ODS preamplifier circuit using a pair of 12AX7s. Clipping of the high gain channel is done via an all-tube Hagerman Clipper circuit, which is an improvement on the original. Classic Dumble equalization is built-in for those sought after tones. Convert your regular tube amp into a D-type by driving it's return loop with this pedal.

Overdriver

Simple, straightforward 12AX7 gain pedal that mimics the tonality of an overdriven tube preamplifier. Clipping is biased towards a cold-clipper for a lot of pleasing crunch along with clean mixed in.

Preamp

This starved-plate tube pedal adds a ton of warmth and woody, organic glow to your acoustic rig. A JFET input provides very high input impedance for direct connection to piezo transducers and an isolated XLR output can go straight to PA. Make your guitar sound on stage like it does in your living room.